Switch Settings for HP-GL/2 Plotter Drivers Reference
Specifies the switches used for the plotter driver.
The following table displays the DIP switch settings for the 7600 240D plotter.
Switch Settings for HP 7600 240D plotter
Switch Bank | 1 | 0 |
---|---|---|
Parallel Left | 2 | 1, 3-10 |
Parallel Right | 3 | 1, 2, 4-10 |
Serial Left | 1 | 2-10 |
Serial Right | 3, 6, 7, 9 | 1, 2, 4, 5, 8, 10 |
The following table displays the DIP switch settings for the 7600 240E plotter.
Switch Settings for HP 7600 240E plotter
Switch Bank | 1 | 0 |
---|---|---|
Parallel Left | 2 | 1, 3-10 |
Parallel Right | 1-10 | |
Serial Left | 1 | 2-10 |
Serial Right | 6, 7, 9 | 1-5, 8, 10 |
For the DraftMaster and 7600 series plotters, follow the Hewlett-Packard instructions
for turning off the monitor mode or turning on the remote mode, stand-alone mode,
XON/XOFF handshake, direct mode, full duplex, 7-bit data, and parity settings. Choose
settings for zero parity and 9600 baud. Be sure the plotter is in HP-GL/2 emulation
mode.
Related References
ecifies the switches used for the plotter driver. The following table displays the DIP switch settings for the 7600 240D plotter. Switch Settings for HP 7600 240D …switches used for the plotter driver. The following table displays the DIP switch settings for the 7600 240D plotter. Switch Settings for HP 7600 240D …References to other sections in this guide are underlined. … The HP Universal Print Driver supports HP-GL/2 and PostScript printer …. Manual deleting of.HP-GL/2 requires leaving the PCL printer language mode and …. examples in this HP-GL/2 section of the manual use semicolons as terminators …… degrees from the zero reference point at which you want to draw the first radius.References in this guide to "the printer" mean any device from this list, including the HP … For details, see the AutoCAD Customization Manual for Release 12.manual PANTONE®* palettes. PANTONE® * Application Palettes are available on the …reference hp LaserJet 2300 …… Allow Manual Duplexing. …… configure the paper tray in the driver by clicking the Update Now button on the …… to send graphics to the printer as a combination of HP–GL2 and raster images .… HP-GL/2 and HP RTL Programming Information …. 1 Here, and throughout this manual, references to “PostScript files” mean files sent to the …configuration dialogs in AutoCAD … AutoCAD will now display a list of available plotter drivers to choose from. … Make sure the "Printer" tab is active, then click on the New button. 3. From the list of available printer drivers select Hewlett Packard HPGL/2 devices v4.0, ADI 4.3 – by HP.HP-GL/2 and PJL are supported by later versions of PCL. PCL is occasionally …. "PCL 5e Technical Reference Manual Part 1" (PDF). Hewlett- Packard.