About-Extracting-Curves-from-Surfaces-Solids-and-Faces

About Extracting Curves from Surfaces, Solids, and Faces

    About Extracting Curves from Surfaces, Solids, and Faces

    When working with surfaces you may want to create non-mesh wireframes displaying
    the contours of a surface to experiment with and regenerate variations. Objects created
    by this process can be lines, plines, splines, or arcs, depending on the surface,
    solid, or face from which they are extracted and the command remains active until
    you press Enter.

    After modifying extracted curves, use the LOFT command to regenerate a surface that
    passes through the extracted objects.

    Options

    Use the chain option to preview and extract adjacent curves.

    NOTE:Adjacent faces, for solids and surfaces, must be parameterized in the same direction.

    The direction option allows you to extract curves in the other direction. Isoline
    curves are extracted in the U direction, by default.

    Choose the spline points option to extract a spline that passes through all specified
    points on the surface.

    Learning AutoCad

    Extract Curves from Surfaces, Solids, and Faces of Solids. Extract lines, plines, splines, or arcs from surfaces and the faces of solids in either the U or V directions. Click to extract an isoline curve represented by the preview line. Curves are extracted in the U direction by default.surfaces you may want to create non-mesh wireframes displaying the contours of a surface to experiment with and regenerate variations.Surface tabCurves panelExtract Isolines. Find Select a surface, solid, or face. At the prompt, enter S to create a custom spline curve. Begin specifiyng points …curves by using the objects as location … Create a curve or polyline that copies a surface, polysurface, or mesh border. … Create a curve that copies a polysurface face border. … Extract object sub-elements …Extract commands extract surfaces from polysurfaces. … Remove mesh faces in order to repair problems with a mesh. … Fit a polyline through curve control points or a mesh through surface control points. ExtractCurvatureGraph. Duplicate a …… If we want to Extract Curves from the borders, or edges of Surfaces, there are … CURVE FROM OBJECTS – DUPLICATE FACE BORDER …face of an element. … Curvature continuity : the extracted element (necessarily a curve) will be … These options are only valid for curves. … a warning message is issued and you are prompted to select a support surface. … such as wire edge, border edges, face, sub-elements of a volume or a solid.curve from the surface of a solid object … Provides options for extracting tangent entities, faces, or all entities; the specific items …extract single surface or curves from the single surface. To extract all the edges or faces of a part, all you have to do …