About-Creating-Angular-Dimensions

About Creating Angular Dimensions

About Creating Angular Dimensions

Angular dimensions measure the angle between two lines or three points.

To measure the angle between two radii of a circle, you select the circle and specify
the angle endpoints. With other objects, you select the objects and then specify the
dimension location. You can also dimension an angle by specifying the angle vertex
and endpoints. As you create the dimension, you can modify the text content and alignment
before specifying the dimension line location.

NOTE:

You can create baseline and continued angular dimensions relative to existing angular
dimensions. Baseline and continued angular dimensions are limited to 180 degrees or
less. To obtain baseline and continued angular dimensions larger than 180 degrees,
use grip editing to stretch the location of the extension line of an existing baseline
or continued dimension.

Dimension Lines

If you use two straight, nonparallel lines to specify an angle, the dimension line
arc spans the angle between the two lines. If the dimension line arc does not meet
one or both of the lines being dimensioned, The program draws one or two extension
lines to intersect the dimension line arc. The arc is always less than 180 degrees.

Dimension Circles and Arcs

If you use an arc or a circle or three points to specify an angle, the program draws
the dimension line arc between the extension lines. The extension lines are drawn
from the angle endpoints to the intersection of the dimension line arc.

The location that you specify for the dimension line arc determines the quadrant of
the dimensioned angle.

Dimension to a Quadrant

Angular dimensions can measure a specific quadrant that is formed when dimensioning
the angle between of the endpoints of a line or arc, center point of a circle, or
two vertices. As an angular dimension is being created, there are four possible angles
that can be measured. By specifying a quadrant it allows you to ensure that the correct
angle is dimensioned. When placing an angular dimension after a quadrant has been
specified, you can place the dimension text outside of the extension lines of the
dimension. The dimension line is automatically extended.

Learning AutoCad

>Creating angular dimensions. Command: DIMANGULAR. Angular dimensions annotate the angle measured between two lines, two linear segments of a …Angular dimensions measure the angle between two lines or three points. To measure the angle between two radii of a circle, you select the circle and specify  …create angular dimensions that measure the angle between two lines or three points. This function also measures …to create angular dimension annotations. Remember that: When the dimension supports are related to a parameter (sketch's …angular dimension between two lines or a line and a model edge. Select the two entities, then move the pointer to observe the dimension …Creating Angular Dimensions. Use the AngleDimension command to dimension angles in a drawing. You can create angular Dimensions formed: Freely by a …angle, use the Angular Dimension tool ( ), which you find … Creating an angular dimension in LayOut.Create angular dimension in Grasshopper 3D.to create an angle dimension and perform the following kinds of modifications: new angle sector or turn an angle sector into a …Creating angular dimensions The ANGLEDIMENSION command (alias DAN, on the Dimension toolbar, or Dimension | Angular main menu) creates angular …