To-Work-With-Slicing-a-Solid-or-Surface

To Work With Slicing a Solid or Surface

    To Work With Slicing a Solid or Surface

    Slice a 3D Solid or Surface With a Cutting Plane

    1. Click Home tabSolid Editing panelSlice. Find
    2. Select the 3D solid or surface objects to slice. Press Enter.
    3. Specify two points to define the cutting plane.
    4. Specify which side of the sliced object to retain, or enter b (Both) to retain both sides.

    Slice a 3D Solid or Surface With a Planar Object

    1. Click Home tabSolid Editing panelSlice. Find
    2. Select the 3D solid or surface objects to slice. Press Enter.
    3. At the Command prompt, enter o (Object). Press Enter.
    4. Select a circle, ellipse, arc, 2D spline, or 2D polyline to use as the cutting plane.
    5. Specify which side of the sliced object to retain, or enter b (Both) to retain both sides.

    Slice a 3D Solid or Surface With a Surface

    1. Click Home tabSolid Editing panelSlice. Find
    2. Select the 3D solid or surface objects to slice. Press Enter.
    3. At the Command prompt, enter s (Surface).
    4. Press Enter.
    5. Select a surface to use as the cutting plane.
    6. Specify which side of the sliced object to retain, or enter b (Both) to retain both sides.

    Learning AutoCad

    >Slice a 3D Solid or Surface With a Cutting Plane Click Home tabSolid Editing panelSlice. Find Select the 3D solid or surface objects to slice. Press Enter. Specify …solids and surfaces by slicing, or dividing, existing objects. Use the SLICE command to slice a 3D solid or surface, you must specify a cutting plane or …Slice a 3D Solid or Surface With a Cutting Plane Click Modeling tab > Solid panel > Slice. Select the 3D solid or surface objects to slice. Press Enter. Specify two …slice a 3D solid object with a surface object, the operation failed. Solution When you are slicing solids with surfaces, only surfaces generated …use SOLIDEDIT command to create a surface using the face of your solid, then you can use the SLICE command to cut using the …to use the SLICE command to carve a solid with a surface. Previously, SLICE was limited to  …surfaces or solids for this … Use the SEPARATE command to break them up. … Slice with Surface.jpgsurfaces. ✓ Slice a solid using various methods. ✓ Construct … example, Figure 11-1 lists the properties of a selected solid sphere.Use the new 3D Modeling tools in AutoCAD 2007 for surface slicing. Required … Turn off all layers except the Handle Base Sketch and the Handle Solid layers.work only with untrimmed surfaces and some software does … Trim a polysurface with a curve similar to cutting foam with a heated wire.