To-Use-Coordinate-Filters-to-Specify-a-Point-in-3D

To Use Coordinate Filters to Specify a Point in 3D

To Use Coordinate Filters to Specify a Point in 3D

  1. At the prompt for a point, enter a coordinate filter (.x, .y, .z, .xy, .xz, or .yz).

    For example, enter .x to specify the X value first.

  2. To extract the specified coordinate values, specify a point.

    For example, if you previously entered .x, the X value is extracted from this point.

  3. At the prompt for the remaining coordinates, do one of the following:
    • Extract the remaining coordinate values by specifying a point.
    • Enter another coordinate filter.

    For example, if you previously entered .x, specify a second point to extract the Y and Z coordinates simultaneously, or enter .y or .z to specify Y and Z values separately.

    The new point location combines the coordinate values extracted from the previously
    specified points.

NOTE:Instead of specifying a point, you can enter a numeric value at any coordinate filter
prompt.

Learning AutoCad

sp>To Use Coordinate Filters to Specify a Point in 3D. At the prompt for a point, enter a coordinate filter (.x, .y, .z, .xy, .xz, or .yz). For example, enter .x to specify the X value first.To Use Coordinate Filters to Specify a Point in 3D. At the prompt for a point, enter a coordinate filter (.x, .y, .z, .xy, .xz, or .yz). For example, enter .x to specify the X value first.3D 2016, AutoCAD Electrical 2016, AutoCAD MEP 2016, AutoCAD Map 3D 2016, …3D 2017, AutoCAD Electrical 2017, AutoCAD MEP 2017, AutoCAD Map 3D 2017, …3D 2015, AutoCAD Electrical 2015, AutoCAD MEP 2015, AutoCAD Map 3D 2015, …3D 2018, AutoCAD Electrical 2018, AutoCAD MEP 2018, AutoCAD Map 3D 2018, …Coordinate filters specify a new coordinate location by using the X value from one … of a second location, and, for 3D coordinates, the Z value of a third location .… At the prompt for a point, enter a coordinate filter (.x or .y). For example, enter .x to specify the X value first. To extract the first coordinate value, …… I will use point filters here to make a circle at a point in 3D space taking … on the command line which is prompting you to specify X coordinate.… Use these filters to place text in the center of a box or move an object in … rectangle and AutoCAD picks up the y and z values from the side's coordinate. It then assembles those values into a point, which is in the exact center of the box. … of lines, to make an object co-linear, or to help when drawing in 3D.