لیسپ های کاربردی اتوکد

To-Create-Paragraphs-With-Hanging-Indentation

To Create Paragraphs With Hanging Indentation

To Create Paragraphs With Hanging Indentation

  1. If the ribbon is active, double-click a multiline text object to open the MTEXT ribbon
    contextual tab. If the ribbon is not active, the In-Place Text Editor is displayed.

  2. Select the paragraphs you want to indent.
  3. On the ruler, slide the top indent marker to where you want the first line of the
    paragraphs to start.

    NOTE:

    The ruler displays the tabs and indents that are set for the selected paragraphs or,
    if no text is selected, the paragraph where the cursor is located. The default tab
    stops are the long tick marks on the ruler. To set a custom tab stop, click the ruler
    where you want the tab stop.

  4. Slide the bottom indent marker to where you want the other lines of the paragraphs
    to start.

    This step indents turnover lines in paragraphs that are more than one line long.

  5. To change the indentation, select the paragraphs you want to change, click the ruler
    to set new tab stops, if needed, and move the indent markers.
  6. To save your changes and exit the editor, use one of the following methods:
    • On the MTEXT ribbon contextual tab, in the Close panel, click Close Text Editor.
    • Click in the drawing outside the editor.
    • Press CTRL+ENTER.

Learning AutoCad