1. Click Surface tabCreate panelBlend. Find
2. Click Home tabSelection panelEdge. Find
   NOTE:If the drawing area is very busy, use the CULLINGOBJ and the CULLINGOBJSELECTION to
   further filter out unneeded objects.

3. In the drawing area, select a surface edge and a solid edge.
4. Specify the continuity and bulge magnitude for each edge and press Enter.

Learning AutoCad

ick Surface tabCreate panelBlend. Find Click Home tabSelection panelEdge. Find Note: If the drawing area is very busy, use the CULLINGOBJ and the …Surface panel > Surface Creation drop-down > Surface Blend. In the drawing area, select a surface edge and a solid edge. Specify the …Create a Surface-to-Surface Blend. Use the Blend Between Surfaces command to create a smooth surface or solid transition between two surfaces.creates a blend surface between two surfaces.create transitions between curves and surfaces.create the rear bracket for our wagon.…While creating this part, we will learn how to produce a smooth transition from…one surface …between a collection of surfaces and a solid. In class I like to use the concept … Then, we're going to throw the corner blend surface away. Next … We'll trim the two side surfaces and the bottom surface to these curves, create a new.SURFBLEND command is used to create a blend surface between two surface edges or two solid edges. When blending surfaces, you select the surface …solid on one side, like below: …. The BlendSrf command creates a blend surface between two surfaces.Surface blends two surfaces that share an edge or intersection. This tool … Lofted Solid tool creates a solid that is tangent between two neighboring solids.