Settings for COM Port Dialog Box
Specifies the baud rate, protocol, flow control, and hardware handshaking for serial
ports on plotters that support these settings.
The settings on your plotter must match the settings in the program or you cannot
List of Options
The following options are displayed.
- Baud Rate
Specifies the baud rate. Use the fastest available baud rate.
Displays the protocol settings available for your plotter. Use the protocol recommended
by your device manufacturer. For more information see the documentation for your device.
- Flow Control
Sets the flow control for your plotter. The default flow control setting is XON/XOFF
(software handshaking) for compatibility with previous versions of the program.
If you select Hardware handshaking, you can specify additional settings in the Advanced
Settings for COM Port dialog box that correspond to different pins on the RS232 connector.
ecifies additional hardware handshaking settings for serial ports. List of Options The following options are displayed. CTS Enables Clear To Send …serial ports on plotters that support these settings. Note: The settings on your …… Once there do the following: Expand the Ports '(COM& LPT)' You should be … In the box that opens, select “Show hidden devices” in the 'view' menu. … When I go to the “properties” dialog for my USB to Serial Port, there is no tab for “port settings. ….. So I understand that it is complex thing to configure it.dialog box for setting FIFO control parameters and selecting a COM port number. However, you can …Setting the correct COM Port number when using the Prolific … In the System Properties Dialog box, select the “Hardware” tab and then double-click the “ Device.… Click the Configure menu, and then click System Hardware. Click Edit. The Hardware Setup Entry dialog box appears. Click Device, and select the communications port you edited in the Control Panel.configure an existing COM port, select the COM port from the Configured Ports field, then select Configure. The Ports dialog box displays. Proceed to step 9. In the Ports dialog box, define the computer name of the Server to which the Workstation will connect, and select Serial Printer.settings for the USB com ports need to match in both SignBlazer and in the device … A new dialog box will appear, called ?Port Setting. Summary … A dialog (screen) entitled System Properties will appear. •. The System Properties has …Settings for Serial Ports set as follow … Select Advanced from Port Settings. … Close the box and you should be asked to reboot.