RECTANG-Command

RECTANG (Command)

RECTANG (Command)

Creates a rectangular polyline.

Find

Creates a rectangular polyline from the specified the rectangle parameters (length,
width, rotation) and type of corners (fillet, chamfer, or square).

The following prompts are displayed.

Current settings: Rotation = 0

Specify first corner point or [Chamfer/Elevation/Fillet/Thickness/Width]: Specify a point or enter an option

First Corner Point

Specifies a corner point of the rectangle.

Other Corner Point

Creates a rectangle using the specified points as diagonally opposite corners.

Area

Creates a rectangle using the area and either a length or a width. If the Chamfer
or Fillet option is active, the area includes the effect of the chamfers or fillets
on the corners of the rectangle.

Dimensions

Creates a rectangle using length and width values.

Rotation

Creates a rectangle at a specified rotation angle.

Chamfer

Sets the chamfer distances for the rectangle.

Elevation

Specifies the elevation of the rectangle.

Fillet

Specifies the fillet radius of the rectangle.

Thickness

Specifies the thickness of the rectangle.

Width

Specifies the polyline width of the rectangle to be drawn.

Learning AutoCad

en using the RECTANGLE command, you have to enter absolute or relative coordinate values to define the size of the rectangle. You want to be able to give  …rectangle parameters (length, width, rotation) and type of corners (fillet, chamfer, or square). … Creates a rectangle using the area and either a length or a width. If the Chamfer or Fillet option is active, the area includes the …… Command: _rectang. Specify first corner point or [Chamfer/Elevation/Fillet/ Thickness/Width]: w // select the width. Specify linewight for rectangle …Rectangle command places a rectangle in the diagram for documentation purposes. The size and shape of the rectangle can be changed. Rectangles are …20 Feb 201621 Jun 2010command to draw a rectangle in AutoCAD 2014. In most cases, you'll find that using the special-purpose RECtang command is …Rectangle commands operate on rectangular areas of the text: all the characters between a certain pair of columns, in a certain range of lines.… AutoCAD Rectangle Command can be accessed in different ways and few are listed below. Method 1: Ribbon Bar Home Tab > Draw Panel …