Ports-Tab-Plotter-Configuration-Editor

Ports Tab (Plotter Configuration Editor)

Ports Tab (Plotter Configuration Editor)

Changes communication settings between the configured plotter and your computer or
network system. You can specify whether you want to plot through a port, plot to a
file, or use AutoSpool. See “Use AutoSpoolâ€‌ in the Driver and Peripheral VCade.

If you plot through a parallel port, you can specify the timeout value. If you plot
through a serial port, you can change the baud rate, protocol, flow control, and input
and output timeout values.

List of Options

The following options are displayed.

Plot to the Following Port

Sends the drawing to the plotter through the selected port.

Plot to File

Sends the drawing to the file specified in the Plot dialog box.

AutoSpool

Uses the AutoSpool utility to plot the drawing. AutoSpool is specified on the Files
tab in the Options dialog box.

Port List

Displays a list and description of available ports, both local and network. If the
port is a network port, the name of the network printer is also displayed.

Show All Ports

Shows all available ports on the computer regardless of the ports available on the
plotter.

Browse Network

Displays the network choices so you can connect to another instance of a nonsystem
plotter.

Configure Port

Displays either the Configure LPT Port dialog box or the Settings for COM Port dialog
box.

Learning AutoCad

>Ports Tab (Plotter Configuration Editor) Changes communication settings between the configured plotter and your computer or network system. You can specify whether you want to plot through a port, plot to a file, or use AutoSpool. See “Use AutoSpool” in the Driver and Peripheral Guide.plotter port connections and output settings, including media , graphics, physical pen … The Plotter Configuration Editor has several tabs.plotter configuration (PC3) file. … The remainder of the tab is read-only. … General Tab (Plotter Configuration Editor) … network server (if the plotter is connected to a network server); I/O port (if the plotter is …Plotter Configuration Editor contains three tabs: General. Contains basic information about the configured plotter. Ports. Contains information about the …Plotter Configuration File Name Displays the file name you assigned in the … server (if the plotter is connected to a network server); I/O port (if the plotter is …Plotter Configuration File Name Displays the file name you assigned in the … server (if the plotter is connected to a network server); I/O port (if the plotter is …Plotter Configuration Editor dialog box. See Figure … Ports tab allows you to send the plot to a port, plot to a file, or select AutoSpool.