FROM-Command-Modifier

FROM (Command Modifier)

FROM (Command Modifier)

Locates a point offset from a reference point within a command.

Object Snap  

At a prompt to locate a point, enter FROM

Base Point:
Specify a point to use as a base point
of <offset:
Enter a relative offset

At a prompt for locating a point, enter FROM, and then enter a temporary reference
or base point from which you can specify an offset to locate the next point. Enter
the offset location from this base point as a relative coordinate, or use direct distance
entry.

NOTE:You cannot use this method during dragging in commands such as MOVE and COPY. Specifying
an absolute coordinate, either by keyboard entry or with a pointing device, cancels
the FROM command.

Learning AutoCad

>FROM (Command Modifier) Locates a point offset from a reference point within a command. At a prompt for locating a point, enter FROM, and then enter a temporary reference or base point from which you can specify an offset to locate the next point.command modifier can be used with …command. Toolbar: Object Snap Command entry: At a prompt to locate a point, enter from Base Point: …command modifier can be used with running object snaps or object snap overrides. (OSNAP command).command modifiers preceding a command, optionally separated by spaces or tabs. As with commands, modifiers must be indented …command following this modifier will be run asynchronously – Opus will not wait for it to exit before running the next command in the function (or before …Nov 23, 2008command modifiers and the commands to which they apply.command–modifier is the command …