Direct-Distance-Entry-Command-Modifier

Direct Distance Entry (Command Modifier)

Direct Distance Entry (Command Modifier)

Locates the next point at a specified distance in the direction of your cursor

At a prompt to locate a point, enter a numeric value

With direct distance entry, you can quickly specify a point relative to the last point
you entered. At any prompt for a point location, you move the cursor first to specify
the direction, and then enter a numeric distance.

In the following example, the second point for the line will be located 5 units toward
the direction of the cursor. The direct distance that you enter is measured along
the path from the last point to the current location of the cursor. This feature is
usually used with Ortho or Snap mode turned on.

Example

Command: LINE

Specify first point: Specify a point

Specify next point: Move the cursor in the desired direction and enter 5

NOTE: The direct distance entry method is not available while you are using temporary override
keys for Ortho, object snap tracking, or polar tracking.

Learning AutoCad

>Direct Distance Entry (Command Modifier) With direct distance entry, you can quickly specify a point relative to the last point you entered. At any prompt for a point location, you move the cursor first to specify the direction, and then enter a numeric distance.Direct Distance Entry is a simplified method of entering distance and direction. … Direct Distance Entry can be used anytime a command prompts for a point.direct distance entry enables you to draw an object, such as a line, … a particular direction with the cursor and entering a distance at the command line …Direct Distance Entry and Osnaps. … In general, you should investigate the command modifier "From".… Click on the links at the end of each topic and explore the command or … Direct Distance Entry (Command Modifier) locates the next point at a …