لیسپ های کاربردی اتوکد

ALIGN-Command

ALIGN (Command)

ALIGN (Command)

Aligns objects with other objects in 2D and 3D.

Find
NOTE:In AutoCAD LT, this command is available only from the command line.

Either one, two, or three pairs of source points and definition points can be specified
to move, rotate, or tilt the selected objects, aligning them with points on another
object.

Specify either one, two, or three pairs of source points and definition points to
align the selected objects.

The following prompts are displayed.

Select objects
Select the objects to align and press Enter.

The next series of prompts asks for source and destination points. The number of point
pairs that you specify determines the results.

First source point, First destination point

When you select only one source point and destination point pair, the selected objects
move in 2D or 3D from the source point (1) to the destination point (2).

First and Second source and destination points

When you select two point pairs, you can move, rotate, and scale the selected objects
to align with other objects.

The first set of source and destination points defines the base point for the alignment
(1, 2). The second set of points defines the angle of rotation (3, 4).

After you enter the second set of points, you are prompted to scale the object. The
distance between the first and second destination points (2, 4) is used as the reference
length to which the object is scaled. Scaling is available only when you are aligning
objects using two point pairs.

NOTE: If you use two source and destination points to perform a 3D alignment on non-perpendicular
working planes, you get unpredictable results.

First, Second, and Third source and destination points

When you select three point pairs, you can move and rotate the selected objects in
3D to align with other objects.

The selected objects move from the source point (1) to the destination point (2).

The selected object is rotated (1 and 3) so that it aligns with the destination object
(2 and 4).

The selected object is then rotated again (3 and 5) so that it aligns with the destination
object (4 and 6).

Learning AutoCad

ther one, two, or three pairs of source points and definition points can be specified to move, rotate, or tilt the selected objects, aligning them with points on another object. Specify either one, two, or three pairs of source points and definition points to align the selected …Dec 20, 2012… Have you ever wanted to move and rotate objects in AutoCAD all in one command? That is exactly what the ALIGN command does, and it can …align attribute specifies the alignment of an <object> element according to the surrounding … For an object to align left or right use the CSS property float.Align Command. Align specifies the default alignment for the mapping process: Align = Value. The starting address of each entity to be mapped is rounded up to  …Align command can be.… The Align command provides a quick way to match the linework in your main drawing to the same location, rotation, and scale as linework and …… Finally you will adjust the 'soon to be angled lines' using the Align command. Make sure your OSnaps are turned on or your drawing will …… A post on Daily AutoCAD , subscribe to this blog if you haven't already, highlights a brilliant but often forgotten editing command. With “Align” …… align performs a sequence alignment followed by a structural … with lower sequence identity, the super and cealign commands perform better.