آموزش تصویری اتوکد دستورات دوبعدی و سه بعدی + ترفندهای اتوکد
About Creating a Solid or Surface by Sweeping
Create a 3D solid or surface by sweeping a profile along a path.
The SWEEP command creates a solid or surface by extending a profile shape (the object
that is swept) along a specified path. When you sweep a profile along a path, the
profile is moved and aligned normal (perpendicular) to the path. Open profiles create
surfaces and closed curves create solids or surfaces.
You can sweep more than one profile object along a path.
Options for Sweeping
When you extrude objects, you can specify any of the following options:
- Mode. Sets whether the sweep creates a surface or a solid.
- Alignment. If the profile is not on the same plane as the sweep path, specify how the profile
aligns with the sweep path.
- Base Point. Specify a base point on the profile to sweep along the profile.
- Scale. Specify a value that will change the size of the object from the beginning of the
sweep to the end. Enter a mathematical expression to constrain the object scaling.
- Twist. By entering a twist angle, the object rotates along the length of the profile. Enter
a mathematical expression to constrain the object â€کs twist angle.
>Create a 3D solid or surface by sweeping a profile along a path. The SWEEP command creates a solid or surface by extending a profile shape (the object that is …Solid panel > Modeling drop-down > Sweep. Select objects to sweep and press Enter. Select an object or edge subobject as a sweep path.creates a solid or surface that extends the shape of a curve. … Sweeping usually provides greater control and better results.swept surfaces and swept area solids with inner … to be consistent with shape representations of the respective building elements.Create > Solid > Protrusion > Sweep | Solid | Done. In the SWEEP … This trajectory is for the outer edge on the bottom surface of the part. The swept section will …sweep you are creating, select one of the following options on the Options … Alternatively, select Solid in the Solid/Surface panel.create swept geometry by dragging a planar section along a trajectory. The section … You can create a solid or surface swept geometry. When creating a …to create a surface or to create a solid using a variable section sweep. Select a trajectory to be used for the variable section sweep. Note: You can …Sweep feature you can create a shape by moving a 2D sketch Profile … Today we will take a closer look to the Sweep feature and the Cut Sweep feature. …. Hi Diogo, make sure you use a Solid Sweep instead of a Surface Sweep.