Creates a 3D polyline.

Find

A 3D polyline is a connected sequence of straight line segments created as a single
object. 3D polylines can be non-coplanar; however, they cannot include arc segments.

The following prompts are displayed.

Start point of polyline

Specifies the first point in the 3d polyline.

Endpoint of line

Draws a straight line from the previous point to the specified new point. The prompt
is repeated until you press Enter to end the command.

Undo

Deletes the last line created. You can continue drawing from the previous point.

Close

Draws a closing line from the endpoint back to the first point, and then ends the
command. To be closed, a 3D polyline must contain at least two lines.

Learning AutoCad

3D polyline is a connected sequence of straight line segments created as a single object. 3D polylines can be non-coplanar; however, they cannot include arc segments. … Specifies the first point in the 3d polyline.3D polyline is a connected sequence of straight line segments created as a single … The prompt is repeated until you press Enter to end the command.3DPOLY] command is available in AutoCAD LT series case? Also tell me about the differences with the 2D polyline.3DPOLY command in the main language versions of AutoCAD: In AutoCAD since version ≤ R12. 3DPOLY command description: Draws a 3D polyline.13 Jan 2011… The 3D Polyline command works in exactly the same way as the Polyline command. The main difference between a normal polyline and a 3D …3DPOLY command. To edit it use the PEDIT command, but it will not allow you to fillet it.